Mechatronics Test Questions Start Creating PDF
Mechatronics Test Questions, this topic has 53 mcqs, It takes five to ten minutes to complete this free mechatronics test questions test. You will see 4 or 5 option of each question. You must choose / think only one option and then press on answer key for check right answer. Practice "mechatronics test questions" MCQs and share with your friends, brothers, sisters.
mechatronics test questions (Total Quiz: 53)
MCQ: If the value of error increases, the changing speed of controller output __________.
- increases
- decreases
- remains constant
- cannot say
C
MCQ: The range of control of controller __________ due to presence of offset.
- increases
- decreases
- remains constant
- cannot say
B
MCQ: Shifting of set point and adjusting its new value by the controller, when the value of disturbance increases, is called as_______.
- set-shift
- offset
- stabilization
- none of the above
B
MCQ: Which of the following is/are the drawback/s of proportional control? 1. Proportional control system is complicated and costly. 2. Proportional control system is not suitable for pressure temperature and flow control problems 3. If there are sudden disturbance, the proportional control system takes time to stabilize.
- (1)
- (2)
- (3)
- (1), (2) and (3)
C
MCQ: __________ is the time required for the response to reach 50% of the final value in the first attempt.
- Rise time
- Peak time
- Settling time
- Delay time
D
MCQ: If the frequency of the input signal to a system is increased, the amplitude of the output _______.
- start reducing
- start increasing
- be remain constant
- be unpredictable
A
MCQ: In all cases of input frequency, if the gain starts reducing, the phase angle will _______.
- start reducing
- start increasing
- be remain constant
- be unpredictable
A
MCQ: What is the ratio of amplitude of response to that of the input called?
- Response
- Gain
- Phase
- Frequency
B
MCQ: Which method is used for stability analysis?
- Nyquisit criteria
- Root locus method
- Routh Hurwitz criteria
- All of the above
D
MCQ: When ___________ contacts are actuated, they disrupt the power supply through them.
- normally open type
- normally closed type
- both a. and b.
- none of the above
B
Related Keywords
- mechatronics
- mechatronics engineering
- mechatronics meaning
- mechatronics and robotics
- mechatronics technology
- mechatronics engineering waterloo