Mechanical System Design Test Questions Start Creating PDF
Mechanical System Design Test Questions, this topic has 57 mcqs, It takes five to ten minutes to complete this free mechanical system design test questions test. You will see 4 or 5 option of each question. You must choose / think only one option and then press on answer key for check right answer. Practice "mechanical system design test questions" MCQs and share with your friends, brothers, sisters.
mechanical system design test questions (Total Quiz: 57)
MCQ: Which of the following ergonomic factors are encountered in engineering applications?
- Thermal radiations
- Lubrication failure
- Fatigue
- Corrosion
C
MCQ: Which of the following statements is/are true about safety/risk?
- Risk is potential for damage
- Hazard is likely hood of damage
- Danger is combination of risk and hazard
- All of the above
C
MCQ: Which of the following processes is used for surface finishing?
- Shaping
- Broaching
- Lapping
- All of the above
C
MCQ: In forging process, forging plane is the plane __________
- parallel to die motion
- perpendicular to die motion
- where two die halves meet
- none of the above
B
MCQ: What are the factors affecting selection of casting process?
- Tolerances
- Surface finish
- Both a. and b.
- None of the above
C
MCQ: Which of the following is a property of bulk load?
- Hardness
- Cake forming tendency
- Suspension part
- Weight
B
MCQ: Which of the following is not a hoisting equipment with lifting gear?
- Cage elevators
- Jib cranes
- Pulleys
- Troughed belts
D
MCQ: What are bulk loads?
- Lump of material
- Single rigid mass
- Homogeneous particles
- Heterogeneous particles
B
MCQ: Which belt conveyor prevents sliding down of material at an inclination of 55° with horizontal?
- Flat belt conveyor
- Troughed belt conveyor
- Blanket belt conveyor
- Woven wire belt conveyors
C
MCQ: Which of the following statements is false for troughed belt conveyors? 1. Troughed belt conveyors use flexible belts 2. They contain five idlers 3. Depth of trough decreases with increasing number of idlers 4. Flexibility of belt increases as depth of trough decreases
- 1 and 2
- 2 and 3
- 3 and 4
- None of the above
C
Related Keywords
- mechanical system design
- mechanical hvac engineer
- mechanical engineering plumbing
- mechanical piping design
- mechanical electrical plumbing engineer
- design of mechanical and electrical systems in buildings