Manufacturing Process Questions Start Creating PDF
Manufacturing Process Questions, this topic has 129 mcqs, It takes five to ten minutes to complete this free manufacturing process questions test. You will see 4 or 5 option of each question. You must choose / think only one option and then press on answer key for check right answer. Practice "manufacturing process questions" MCQs and share with your friends, brothers, sisters.
manufacturing process questions (Total Quiz: 129)
MCQ: The point at which the cutting tool reaches, beyond which it will not function satisfactorily until it is reground, is called as
- tool wear
- tool failure
- too diffusion
- none of the above
B
MCQ: Which cutting condition affects the cutting temperature predominantly?
- depth of cut
- cutting speed
- feed
- none of the above has any effect on cutting temperature
B
MCQ: In metal cutting operation, maximum heat (i.e. 80-85%) is generated in
- the shear zone
- the chip-tool interface zone
- the tool-work interface zone
- none of the above
A
MCQ: The forces required for metal cutting operation
- increase with increase in the feed of the tool and decreases with increase in the depth of cut
- decrease with increase in the feed of the tool and increases with increase in the depth of cut
- increase with increase in both the feed of the tool and the depth of cut
- decrease with increase in both the feed of the tool and the depth of cut
C
MCQ: Which fixtures are used for machining parts which must have machined details evenly spaced?
- Profile fixtures
- Duplex fixtures
- Indexing fixtures
- None of the above
C
MCQ: The device which is used to remove workpiece from close-fitting locators, after the workpiece has been removed is called as
- remover
- ejector
- escaper
- blocker
B
MCQ: V-blocks (Vee locators) are used for clamping as well as locating when faces are inclined upto
- 30°
- 12°
- 9°
- 3°
D
MCQ: The device which place the workpiece in the same position, in jig and fixture, cycle after cycle is called as
- placing device
- fixing device
- locating device
- positioning device
C
MCQ: Which machine tool reduces the number of set-ups in machining operation, time spent in setting machine tools and transportation between sections of machines?
- Computer Numerical Control machine tool
- Direct Numerical Control machine tool
- Adaptive Control Systems
- Machining centre
D
MCQ: The machine tool, in which calculation and setting of the operating conditions like depth of cut, feed, speed are done during the machining by the control system itself, is called
- Computer Numerical Control System
- Direct Numerical Control System
- Machining Centre System
- Adaptive Control System
D
Related Keywords
- interview questions for quality assurance in manufacturing
- manufacturing process
- lean production
- die casting
- production planning
- manufacturing execution system
- rapid manufacturing
- production planning and control
- plastic manufacturing
- lean production system
- continuous manufacturing
- plastic manufacturing process
- cold chamber die casting
- production of steel
- manufacturing process management
- toyota manufacturing process
- rubber manufacturing process
- production system in manufacturing