Electric Power Utilization Test Questions Start Creating PDF
Electric Power Utilization Test Questions, this topic has 101 mcqs, It takes five to ten minutes to complete this free electric power utilization test questions test. You will see 4 or 5 option of each question. You must choose / think only one option and then press on answer key for check right answer. Practice "electric power utilization test questions" MCQs and share with your friends, brothers, sisters.
electric power utilization test questions (Total Quiz: 101)
MCQ: For a good weld,
- Cross - section of the added metal should be small and oxidation should be minimum
- Cross - section of the added metal should be small and oxidation should be maximum
- Cross - section of the added metal should be large and oxidation should be minimum
- Cross - section of the added metal should be large and oxidation should be maximum
A
MCQ: The advantage of rectifier type welding set is
- Reduced no - load losses
- Easy arc starting
- Less hazardous
- Both (a) and (b)
D
MCQ: The voltage - current characteristics of the arc welding must be
- Exponentially rising
- Drooping
- Straight line
- Parabolic
B
MCQ: Spot welding is used to weld metal pieces whose thickness
- Should be greater than 12 mm
- Lesser than 12 mm
- Lies between 15 to 20 mm
- Greater than 20 mm
B
MCQ: The electrodes used for projection welding are
- Flat and smaller in diameter
- Flat and larger in diameter
- Round and smaller in diameter
- Round and larger in diameter
B
MCQ: In percussion welding, the heat is produced by a rapid discharge of stored electrical energy from
- Capacitor
- Inductor
- Resistor
- Transformer
A
MCQ: Seam welding is not used for the
- Welding in tanks
- Welding in transformers
- Welding in air crafts
- Welding alloys of copper
D
MCQ: The lighting system of almost all the earlier coaches and all the newly manufactured coaches has
- 50 V
- 110 V
- 220 V
- 420 V
B
MCQ: Pantograph collector is used in railways where the train runs at 100 to 130 kmph. Which among the following is true about pantograph collector?
- It is unidirectional
- The erection of the overhead network is complicated
- Its height cannot be varied
- None of these
D
MCQ: A low frequency supply is given to the single phase AC system for track electrification because
- It improves commutation
- Increases efficiency
- Improves power factor
- All of these
D
Related Keywords
- digital electric meters
- removing electric meter
- three phase electric meter price
- electricity meter company